Support for All Siraya Tech Resins
Here you will get support information for our resins, including exposure, post-processing, mechanical properties and documentations.
Exposure Recommendation
Blu likes to be printed at higher temperature. It can be printed faster and with stronger results when it is pre-heated to 28C and even better if user pre-heat the build plate
​
** RESIN EXPOSURE FINDER does not work well for transparent resins like Blu
​
Anycubic Photon (see below)
Phrozen Shuffle / XL 7s for 50um (reported by users).
​Anycubic Photon (Without Pre-heating)
Layer height: 50um
Normal Exposure time: 12 secs
Offtime: 6.5 secs
Bottom Exposure Time: 90 secs
Bottom layers: 8
​Anycubic Photon (With Pre-heating)
Layer height: 50um
Normal Exposure time: 10 secs
Offtime: 6.5 secs
Bottom Exposure Time: 30 secs
Bottom layers: 6
​
​
Post Processing
Cleaning Solution: Ethanol (preferred) or IPA
Cleaning Method: Use painter brush to remove uncured resins. Ultrasonic cleaner is not needed.
​
Post-Curing: 390-405nm UV light for about 10 minutes. As long as it is no longer sticky, it is fully cleaned and cured.
Mechanical Properties
​Shore D 85
Tensile Strength 44Mpa
Young’s Modulus 1500Mpa
Elongation At Break: 25%
Exposure Recommendation
Blu likes to be printed at higher temperature. It can be printed faster and with stronger results when it is pre-heated to 28C and even better if user pre-heat the build plate
​
** RESIN EXPOSURE FINDER does not work well for transparent resins like Blu
​
Anycubic Photon (see below)
Phrozen Shuffle / XL 7s for 50um (reported by users).
Mechanical Properties
​Shore D 85
Tensile Strength 44Mpa
Young’s Modulus 1500Mpa
Elongation At Break: 25%
Exposure Recommendation
Blu, Sculpt, and Tenacious like to be printed at a higher temperature. It can be printed faster and with stronger results when it is pre-heated to 28C and even better if user pre-heat the build plate with hairdryer. You should at least keep the environment temperature over 20C if you don't have an internal heater for the printer.
** RESIN EXPOSURE FINDER does not work well for transparent resins like Blu
Post Processing
Cleaning Solution: Ethanol (preferred) or IPA
Cleaning Method: Use painter brush to remove uncured resins. Ultrasonic cleaner is not needed.
​
Post-Curing: 390-405nm UV light for about 10 minutes. As long as it is no longer sticky, it is fully cleaned and cured.
Post Processing
Cleaning Solution: Ethanol (preferred) or IPA
Cleaning Method: Use painter brush to remove uncured resins. Ultrasonic cleaner is not needed.
​
Post-Curing: 390-405nm UV light for about 10 minutes. As long as it is no longer sticky, it is fully cleaned and cured.
Mechanical Properties for Blu
​Shore D 85
Tensile Strength 44Mpa
Young’s Modulus 1500Mpa
Elongation At Break: 25%
​